Great Lights - Had to bypass the ballast

Ok, took me a little time to figure out the wiring since mine did not work with my ballast. I had to bypass it. I know every ballast is different so this is how I had to wire mine to bypass it and make the lights work.
My ballast is or rather was a Sunpark SL15T.
On one side it has 2 Red Wires and 2 Blue Wires.
On the other side it has the Black and White, as well as 2 Yellow and a Red and a Blu wire.
I disconnected the Black and White wires then cut all the wires close to the ballast.
Then I removed the ballast.
I had to wire the 2 Red and 2 Blue (all from the same side) to the White wire.
Then on the other I Wired the 2 yellow, the Red and the Blue to the Black wire.
(note if you need more wire for the one side like I did just use the white or black wire that is on the ballast or use another wire to connect)

See my images.

Everything worked great after that, the lights are super bright and seem really well made.
The packaging is also very nice, I was impressed that each light was in its own protective tube for shipping.
I purchased the clear light.

Sanlibang Lighting solutions for office environment

In today corporate world, sustainability is a must. "LED Light Tubes" Lighting Solution offers state-of-the-art lighting systems that save energy, protect the environment and your company reputation, and keep your total cost of ownership down.

此博客中的热门博文

LED Light Glare occurs in the following three forms

Glare is a two-fold problem in which lights are reflected off surrounding surfaces so that the light scatters and causes vision problems. It doesn’t interfere with night vision, but makes it difficult to identify and place objects. For the problems of LED glare, all the manufacturers have adopted a variety of methods，some use the brushed PC mask ，others adopt the frosted mask or use the special phosphor materials, etc. , but these methods are not ideal, the drawing masks can eliminate glare, but the flare phenomenon is more serious , our eye tend to be fatigue under this lamp, if we are exposed to it over a prolonged period of time , but also cause eye astigmatism ; while the light loss of those using the mask and cream frosted is too large , the effect is bad. The wrong kind of light, or too much light has been proven to have an impact on your health and quality of life. Glare occurs in the following three forms: Discomfort Glare – Discomfort glare is also known as psycho

阅读全文

Squaward Tentacles Bold and Brash

I saw this and I was immediately transported to my childhood addiction to SpongeBob Squarepants. SpongeBob SquarePants is an American animated television series created by marine .... Instead of continuing his education with a traditional art program, Hillenburg chose to study experimental animation at the California Institute of the Arts.

阅读全文

Open the camera's camera at the LED light bulb, if there is a high frequency flashing, then prove that this LED lights there is a serious problem of strobe.

Open the camera's camera at the LED light bulb, if there is a high frequency flashing, then prove that this LED lights there is a serious problem of strobe. LED light source and light strobe LED light source and lamp strobe mainly from the poor drive power supply, such as RC capacitive power supply, ripple high switching power supply. Test and determine the LED light source and the lamp is stroboscopic, the simple way is to open the phone camera and camera function, electronic viewfinder that lens alignment to observe the LED light source, framing screen accounted for more than 2/3 of the phone screen, Is close to the LED light source observation, such as mobile phone LCD screen to see the light source has obvious black stripes rolling or bright and dark changes, you can determine the strobe. Strobe is the frequency of flashing, is a cyclical repetitive flash, including visible strobe and unobtrusive strobe. 50 to 200Hz frequency flashing human can see the naked eye, for chi

阅读全文

led light htlights

搜索此博客